Owners manual

10
UniFi® Controller User Guide
Ubiquiti Networks, Inc.
Chapter 2: Using the UniFi Controller Software
Remote User VPN
• IP/Subnet Enter the IP address and prefix size.
• IP Pool The starting and ending IP addresses of the
pool automatically appear after you complete the
IP/Subnet field.
• RADIUS IP Enter the IP address of the RADIUS server,
which is used for authentication.
• RADIUS Password Enter the password of the RADIUS
server.
• Save Click to apply changes.
• Cancel Click
CANCEL
to discard changes.
Site-to-Site VPN
• Remote Site Select the appropriate site from the
drop-down list.
Note: If you have admin privileges for the local and
remote sites, then you can view and select sites.
• Save Click
to apply changes.
• Cancel Click
CANCEL
to discard changes.
Voice
In most cases the Voice network is automatically created
when you enable VoIP (refer to “Settings > VoIP” on page
16). If you need to manually create a Voice network,
then configure the following settings:
• IP/Subnet Enter the IP address and prefix size.
• DHCP Server Enabled by default. The local DHCP server
assigns IP addresses to DHCP clients on the network.
• DHCP Range Enter the starting and ending IP
addresses of the range in the fields provided.
• Save Click
to apply changes.
• Cancel Click
CANCEL
to discard changes.
VLAN Only
• VLAN Enter the ID number of the VLAN. This is a unique
value assigned to each VLAN at a single device; every
VLAN ID represents a different VLAN. The VLAN ID range
is 2 to 4009.
• Save Click to apply changes.
• Cancel Click
CANCEL
to discard changes.