Owners manual

38
Chapter 10: Access Point DetailsUniFi AP/AP-LR User Guide
Ubiquiti Networks, Inc.
Access Point - Pending Approval
When an Access Point is in Pending Approval state, this
indicates that the Access Point is in the default state and is
available for adoption.
MAC address Displays the MAC address of the Access
Point.
Model Displays the model information.
Version Displays the version of software used on the
Access Point.
Last Seen Displays the amount of time that has passed
since the Access Point was last seen.
Locate Click to flash the LED on the Access Point and flash
the Access Point icon on the map.
Adopt Click to adopt the Access Point so you can manage
it using the UniFi Controller software.
Forget this AP
Forget Click to remove the Access Point from
management by the UniFi Controller software and to
restore it to factory default settings.
Note: Use caution when clicking forget. This will
restore the Access Point to factory settings when in a
Connected state. Do not use the Forget option when
the Access Point is in an Isolated state. If you do, the
only way to make the Access Point accessible from
the UniFi Controller is to take it down and connect
by wire.