Owners manual

33
Chapter 10: Access Point DetailsUniFi AP/AP-LR User Guide
Ubiquiti Networks, Inc.
Configuration
Allows you to change device configuration settings. Click
the apply button to commit any changes.
Config
General Settings
Alias Allows you to name the device.
Radio (11n/b/g)
Channel Select a channel or leave the default auto
setting. You can also use the default HT20 for 20 MHz
operation or HT40 for 40 MHz operation.
Tx Power By default the transmit power is set to Auto. You
can also manually select High, Medium, Low or Custom.
 High The highest TX power we can deliver.
 Low The lowest TX power.
 Medium Halfway in between High and Low.
 Custom Full custom setting. If the AP is using an
external antenna, the Antenna Gain field will appear
allowing you to specify the gain of the attached
antenna. After applying the settings, go to Transmit
Power under Detail > Radio (11/n/g/b), which always
shows EIRP, mouseover it to display how it’s calculated
Compatibility Selects the wireless compatibility mode. By
default this is set to auto. Choose one of the following:
 Auto Supports wireless b/g/n standards.
 11n/11g only Only supports wireless-n and wireless-g
devices.

11n only Only supports wireless-n devices.
 11g only Only supports wireless-g devices.
Click apply to save any changes that you have made.
WLANs
Allows the deployment of different WLANs on different
Acess Points.
Name Displays the name of the SSID (network name) of
the wireless LAN (WLAN) that is available for the user to
connect to.
Overrides Displays SSID override information applied
to the wireless LAN (WLAN) using the Actions > Override
option.
Actions Click Override to enable a VLAN, set the VLAN ID,
and enter the SSID override name to apply to the wireless
LAN (WLAN).