8-Port Power over Ethernet Managed Switch PRO Model: TS-8-PRO
Introduction Introduction Thank you for purchasing the Ubiquiti Networks TOUGHSwitch™ PoE PRO, model TS-8-PRO. It is part of the TOUGHSwitch series: Name Model Description TOUGHSwitch PoE TS-5-POE 5-port managed switch featuring 24V PoE TOUGHSwitch PoE PRO TS-8-PRO 8-port managed switch featuring 24V or 48V PoE TOUGHSwitch PoE CARRIER TS-16-CARRIER Two TOUGHSwitch PoE PROs mounted in a rack For more information, visit www.ubnt.com.
TOUGHSwitch™ PoE PRO Quick Start Guide Hardware Back Panel Ventilation Holes Power Note: There are additional ventilation holes on the top and sides of the TOUGHSwitch. Front Panel Ports Management 1-8 USB Interface Management 2 Reset Description 10/100 Mbps port for management. Traffic between the Management port and numbered ports will be limited to 10/100 Mbps and, under heavy load, may cause performance degradation of the TOUGHSwitch. USB Reserved for future use.
Hardware Front Panel LEDs Power/Link/Act Speed/Link/Act PoE Management LED Power/ Link/Act 1-8 PoE Speed/ Link/Act State Status Off No power Amber After bootup, the LED indicates power. After an initial link is established, the LED indicates a 10/100 Mbps connection. If the link terminates, the LED turns off until a link is re-established. If the unit reboots, the LED will again indicate power until a link is established.
TOUGHSwitch™ PoE PRO Quick Start Guide Hardware Installation Place the TOUGHSwitch on a bench top or other flat surface. Note: Keep 20 mm of clearance next to the ventilation holes for adequate airflow. Connecting Power 1. Connect the Power Cord to the Power port of the TOUGHSwitch. 2. Connect the other end of the Power Cord to a power outlet.
Hardware Installation Connecting Ethernet 1. Connect an Ethernet cable from the Ethernet port of your computer to the Management port of the TOUGHSwitch. 2. Connect Ethernet cables from the Ethernet ports of your devices to the numbered ports of the TOUGHSwitch. Note: PoE is disabled by default on all numbered ports and is not available on the Management port. To enable PoE on the appropriate ports, use the Ports tab in the Configuration Interface.
TOUGHSwitch™ PoE PRO Quick Start Guide Accessing the Configuration Interface Connect to the Configuration Interface by performing the following steps: 1. Ensure that your computer (or other host machine) is connected to the Management port on the TOUGHSwitch. Note: By default, you can configure the TOUGHSwitch via any port; however, we recommend the Management port. (Access to the Configuration Interface can be limited to the Management port only. You can configure this setting on the Device tab.) 2.
Specifications Specifications TOUGHSwitch PoE PRO Dimensions Weight Power Input Max. Power Consumption PoE Out Voltage Range Max. PoE Wattage Per Data Port ESD Rating PoE Method Button USB Port Processor System Memory Code Storage Certifications Operating Temperature Operating Humidity 210 x 185 x 41 mm 1.24 kg 110-120VAC / 210-230VAC 150 W 45-48VDC / 22-24VDC 18W 24 kV Air / 24 kV Contact Passive Reset 2.
TOUGHSwitch™ PoE PRO Quick Start Guide Safety Notices 1. Read, follow, and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in location that can be submerged by water. WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning. Electrical Safety Information 1.
General Warranty General Warranty UBIQUITI NETWORKS, Inc (“UBIQUITI NETWORKS”) represents and warrants that the Products furnished hereunder shall be free from defects in material and workmanship for a period of one (1) year from the date of shipment by UBIQUITI NETWORKS under normal use and operation. UBIQUITI NETWORKS sole and exclusive obligation under the foregoing warranty shall be to repair or replace, at its option, any defective Product that fails during the warranty period.
TOUGHSwitch™ PoE PRO Quick Start Guide Returns In the unlikely event a defect occurs, please work through the dealer or distributor from which this product was purchased. Compliance FCC Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.
Compliance Cet appareil est conforme à la norme RSS Industrie Canada exempts de licence norme(s). Son fonctionnement est soumis aux deux conditions suivantes: 1. Cet appareil ne peut pas provoquer d’interférences et 2. Cet appareil doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement du dispositif. CE Marking CE marking on this product represents the product is in compliance with all directives that are applicable to it.
TOUGHSwitch™ PoE PRO Quick Start Guide RoHS/WEEE Compliance Statement English European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams.
Compliance Français La directive européenne 2002/96/CE exige que l’équipement sur lequel est apposé ce symbole sur le produit et/ou son emballage ne soit pas jeté avec les autres ordures ménagères. Ce symbole indique que le produit doit être éliminé dans un circuit distinct de celui pour les déchets des ménages.
TOUGHSwitch™ PoE PRO Quick Start Guide Declaration of Conformity Česky [Czech] UBIQUITI NETWORKS tímto prohla uje, e tento UBIQUITI NETWORKS device, je ve shod se základními po adavky a dal ími p íslu n mi ustanoveními sm rnice 1999/5/ES. Dansk [Danish] Undertegnede UBIQUITI NETWORKS erklærer herved, at følgende udstyr UBIQUITI NETWORKS device, overholder de væsentlige krav og øvrige relevante krav i direktiv 1999/5/EF.
Declaration of Conformity Latviski [Latvian] Ar o UBIQUITI NETWORKS deklar , ka UBIQUITI NETWORKS device, atbilst Direkt vas 1999/5/EK b tiskaj m pras b m un citiem ar to saist tajiem noteikumiem. Lietuviškai [Lithuanian] UBIQUITI NETWORKS deklaruoja, kad šis UBIQUITI NETWORKS įrenginys atitinka esminius reikalavimus ir kitas 1999/5/EB Direktyvos nuostatas.
English We recommend that you protect your networks from the most brutal environments and devastating ESD attacks with industrial‑grade shielded Ethernet cable from Ubiquiti Networks. For more details, visit www.ubnt.com/toughcable Deutsch Schützen Sie Ihre Netzwerke vor extremen Umwelteinflüssen und verheerender elektrostatischer Entladung (ESD), indem Sie abgeschirmte Ethernetkabel in Unternehmensqualität von Ubiquiti Networks verwenden. Weitere Informationen erhalten Sie unter www.ubnt.
Ubiquiti Networks Support Email: support@ubnt.com Phone (9 a.m. - 5 p.m. PST): 408-942-1153 Online Resources Wiki Page: wiki.ubnt.com Support Forum: forum.ubnt.com Downloads: downloads.ubnt.com www.ubnt.com © 2012 Ubiquiti Networks, Inc. All rights reserved.
