Instruction Manual

14
Chapter 3: Main TabairOS
™
v5.5.4 User Guide
Ubiquiti Networks, Inc.
• airMAX Capacity This is an index of the maximum data
rate the link is operating at. A lower capacity number
indicates a unit that is slowing down the system.
• Last IP Displays the station’s last IP address.
• TX/RX Rate Displays the data rates, in Mbps, of the last
transmitted and received packets.
• TX/RX Bit Rate Displays the data rates, in bps, of the
last transmitted and received packets.
• TX/RX Packets Displays the total number of packets
transmitted and received from the station during the
connection uptime.
• TX/RX Packet Rate, pps Displays the mean value of the
transmitted and received packet rates.
• Bytes Transmitted Displays the total amount of data
(in bytes) transmitted during the connection.
• Bytes Received Displays the total amount of data (in
bytes) received during the connection.
• Negotiated Rate/Last Signal, dBm Values represent
the received wireless signal level along with the data
rates of recently received packets. N/A is displayed as the
Last Signal if no packets were received on that specific
data rate.
• Kick To drop the connection to the station, click Kick.
• Refresh To update the information, click Refresh.
• Close To close the Station Info window, click Close.
AP Information
(Available in Station mode only.) This selection lists the
connection statistics of the AP associated with the device.
Access Point Displays the MAC address of the AP.
Device Name Displays the host name of the AP.
Product Displays the product name of the device.
Firmware Displays the firmware version of airOS.
Connection Time Displays the amount of time the device
has been connected to the AP. The time is expressed in
days, hours, minutes, and seconds.
Signal Strength The value represents, in dBm, the last
received wireless signal level.
Noise Floor Displays the current value (in dBm) of the
environmental noise (from interference) the receiver hears
on the operating frequency. airOS considers the Noise
Floor while evaluating the signal quality (Signal-to-Noise
Ratio SNR, RSSI). The value mean depends on the signal
strength above the Noise Floor.
CCQ The value represents the quality of the connection to
the AP. This index evaluates the wireless Client Connection
Quality (CCQ). The level is a percentage value for which
100% corresponds to a perfect link state.
Last IP Displays the device’s last IP address.
TX/RX Rate Displays the data rates, in Mbps, of the last
transmitted and received packets.
TX/RX Bit Rate Displays the data rates, in bps, of the last
transmitted and received packets.
TX/RX Packets Displays the total number of packets
transmitted and received from the station during the
connection uptime.
TX/RX Packet Rate, pps Displays the mean value of the
transmitted and received packet rates.
Bytes Transmitted Displays the total amount of data (in
bytes) transmitted during the connection.
Bytes Received Displays the total amount of data (in
bytes) received during the connection.
Negotiated Rate/Last Signal, dBm Values represent the
received wireless signal level along with the data rates
of recently received packets. N/A is displayed as the Last
Signal if no packets were received on that specific data
rate.
Reconnect To establish the wireless link to the AP again,
click Reconnect.
Refresh To update the information, click Refresh.
Interfaces
Displays the name, MAC address, MTU, IP address, and
traffic information for the device’s interfaces.
Interface Displays the name of the interface.
MAC Address Displays the MAC address of the interface.
MTU Displays the Maximum Transmission Unit (MTU),
which is the maximum packet size (in bytes) that a
network interface can transmit. The default is 1500.
IP Address Displays the IP address of the interface.