Quick Start Guide
Wall Mount
The included Wall Mount Bracket allows the NanoStation loco
to be mounted on a wall or flat surface using the ScrewKit that
came with the NanoStation loco.
1. Secure the Wall-Mount Bracket to the wall using the two
Screws. Depending on the type of wall material, there are
also two Screw Anchors included for added stability.
2. Attach the NanoStation loco to the wall by aligning it with
the Wall-Mount Bracket and sliding it down into the slots of
the bracket until it is secure.
3. Connect the power using one of the following options:
• Using the included Gigabit PoE Adapter: Go to
“Connecting to the PoE Adapter”.
• Using a separate PoE switch: Connect the Ethernet cable
from the NanoStation loco’s Ethernet port to a PoE-
enabled Ethernet port on the switch.
WARNING: The switch port must comply with the
power specifications listed in the Specifications
section of this Quick Start Guide.