Install Guide

6. Attach Antenna to Mounting Pole
6
5
5. Install Bushing to Feed Support
2
1. Install Feed Support to Dish Bracket
Install Feed Support to Dish Bracket by:
M6 Bolt-Springlock-Washer Assembly (Qty. 4)
Route network cable through the bottom hole of the Feed Support
and attach to the RJ-45 slot on the back of the Antenna Feed.
Insert Antenna Feed into Feed Support as the orientation shown
in the picture.
Mounting bracket can accommodate 1.25"-2.2" pole.
Attach antenna assembly to pole by:
M6 U-Bolt (Qty. 1)
Pole Bracket Clamp (Qty. 1)
M6 Serrated Flange Nut (Qty. 2)
Wrap network cable with the Bushing and then slide it into the hole
in the Feed Support.
C
Install Dish Bracket to Dish by:
M6X12 Carriage Bolt (Qty. 4)
M6 Serrated Flange Nut (Qty. 4)
D
C
B
C
C
J
B
A
D
2. Install Dish Bracket to Dish
1
3.Connect Network Cable to Antenna Feed
3
H
G
I
F
E
I
4
4. Install Antenna Feed
CH
D
D
I
G
A
B
B
JC
C
C
FEI