Setup guide
Page 8
Page 9
• In the browser address bar type http://192.168.10.20 (the new address of the Nano) then press the
Enter key.
• Click on the Link setup tab, then on Select (second line at right):
• Click on Change, wait; click Apply at top of new page, wait a few seconds for connection (some
access points take a while to connect). That’s it. There should be 3 or more LEDs lit on the back of
the Nano.
This is the
strongest in the list.
Any gure lower
than about 90 is
normally usable.
Select a strong signal
(without encryption)
by clicking in the button.
Then click “Select”
Clicking once on
“Signal” will sort the
list with the strongest
one at the bottom
• Optional: to verify the connection, click on Main tab. This page has no settings, only information to
conrm a connection. (You may have to refresh the browser page after a while).
A number here
means that the
Nanostation has
associated with the
WIFI station
A number here
means that the
Nanostation has
received an IP
address
(also see below).
This number
will increase with
long distance
connections
Note: The numbers here tell us that the
WIFI access point has assigned all the
necessary numbers to the Nanostation
for connecting to the internet.
Numbers will vary with access points.
If blank, internet access will not work.
3 Connecting to a WIFI signal