Setup guide

Page 4
Page 5
Setting up the Nano
• Open your browser (e.g. Internet Explorer, Firefox, Opera, etc.) and type in address bar:
http://192.168.1.20 (the default address of the Nano) then press the Enter key.
• Type in ubnt twice and click OK →
(If this window did not appear, there may be
a problem with the wiring, the network card
or a rewall).
• Select the Network tab and change Nano settings as follows:
2
The Nanostation will act as a router
which makes WIFI cruising much easier.
(This refers to the WIFI side of the Nanostation)
The Nano will automatically be assigned an IP
address, gateway and DNS server by the WIFI
access point you connect to later.
• Click Change
(This refers to the local wired side = you)
This will be the Nano’s new IP address
Always so
Allows the LAN to communicate with the WLAN
Will allow you to connect a computer which has
it’s network setting to “Obtain an IP address and
DNS server automatically”.