mA Selling Mount Motion Sensor Hardware Installation This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful Interference, and 2. This device must accept any interference received, Including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits fora Class A digital device, pursuant to part 15 of the FCC Rules.
mA Selling Mount Motion Sensor Microwave Sensitivity Knob The knob is located inside the product casing. Typically there Is no need to adjust the sensitivity of the microwave sensor; however, you can tum the knob counter-dock wise {towards MIN) or clockwise (towards MAX) to make adjustments. MIN" MAX If you need to access the microwave sensitivity knob or Jumper settings (see page 9), remove the back panel, Use a Phillips screwdriver to remove the three screws.
mA Selling Mount Motion Sensor Electrical Safety information 1. Compliance Is required with respect to voltage, frequency. and ‘current requirements Indicated on the manufacturers label. Connection to different power source than those specified may result in improper operation, damage to the equipment ar pose a ire hazard f the Imitations are not followed. 2. Thar are na operator serviceable parts Inside this equipment. Vicar should ba provided only by a qualified service technician.
mA Selling Mount Motion Sensor LED Specifications The LED are disabled by default and can only be enabled m > by opening the product case and adjusting the Jumper.