User's Manual

Hardware Installation

Note: By default, the Signal LEDs represent the wireless

signal strength with default threshold values. In the airOS

interface, you can modify the threshold values for each

LED or configure the LEDs to display the GPS connection

quality instead. The settings can be configured on the

Advanced tab under Signal LED Thresholds.

Hardware Installation

To install the PowerBridge M5 X3, perform the following steps:

1. Use a flathead screwdriver to unlock the cover. Turn the screw

counter-clockwise until it is loose. The screw remains attached

to the cover. Lift the cover by pressing down and raising it up.

2. Connect an Ethernet cable and the GPS Patch Antenna. There

are grooves for the cables on the cover. Align them properly

and slide the cover back on and secure it with the screw.