User's Manual

PowerBridge M5 X3

(II) No modification, alteration or addition has been made to

the Product by persons other than UBIQUITI NETWORKS

or UBIQUITI NETWORK’S authorized representatives or

otherwise approved by UBIQUITI NETWORKS.

(III) The Product has been properly installed and used at all times

in accordance, and in all material respects, with the applicable

Product documentation.

(IV) All Ethernet cabling runs use CAT5 (or above) shielded cabling.

Disclaimer: UBIQUITI NETWORKS does not warrant that the

operation of the products is error-free or that operation will

be uninterrupted. In no event shall UBIQUITI NETWORKS be

responsible for damages or claims of any nature or description

relating to system performance, including coverage, buyer’s

selection of products for buyer’s application and/or failure of

products to meet government or regulatory requirements.

Returns

In the unlikely event a defect occurs, please work through the

dealer or distributor from which this product was purchased.

Compliance

FCC

Changes or modifications not expressly approved by Ubiquiti

Networks, Inc. could void the user’s authority to operate the

equipment.

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions:

1. This device may not cause interference, and

2. This device must accept any interference, including

interference that may cause undesired operation of the device.

NOTE: This equipment has been tested and found to comply

with the limits for a Class A digital device, pursuant to part 15 of

the FCC Rules. These limits are designed to provice reasonable

protection against harmful interference when the equipment

is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instruction manual, may