Carrier Class AirMax BaseStation
Introduction Introduction Thank you for purchasing the PowerBridge M5 X3. This is a pointto-point CPE wireless device. Package Contents PowerBridge M5 X3 48V PoE Adapter Power Cord Antenna Bracket Clamps (Qty. 2) Pole Bracket Clamps (Qty. 2) Carrier Class AirMax BaseStation M8X135 Carriage Bolts (Qty. 4) Serrated Flange Bolts (Qty. 4) Serrated Flange Lock Nuts (Qty.
PowerBridge M5 X3 Hardware Overview Cover Ethernet Port Connects to GPS Patch Antenna LEDs Power The Power LED will light steady green when the PowerBridge is connected to a power source. Ethernet The Ethernet LED will light steady green when an active Ethernet connection is made and flash when there is activity. GPS The GPS LED lights up green when the GPS signal strength can sustain AirSync operation. This requires a minimum of 3 satellite connections.
Hardware Installation Note: By default, the Signal LEDs represent the wireless signal strength with default threshold values. In the airOS interface, you can modify the threshold values for each LED or configure the LEDs to display the GPS connection quality instead. The settings can be configured on the Advanced tab under Signal LED Thresholds. Hardware Installation To install the PowerBridge M5 X3, perform the following steps: 1. Use a flathead screwdriver to unlock the cover.
PowerBridge M5 X3 3. Insert the M8X135 Carriage Bolts into the Antenna Bracket Clamps. 4. Connect the Antenna Bracket Clamps to the PowerBridge using the four Serrated Flange Bolts.
Hardware Installation 5. Mount the PowerBridge to the pole by performing the following steps: a. Position the PowerBridge in the desired mounting location on the pole. b. Slide the Pole Bracket Clamps on to the Carriage Bolts. c. Use the four Serrated Flange Lock Nuts to secure the PowerBridge to the pole. 6. Adjust the operating angle of the PowerBridge by adjusting the Serrated Flange Bolts on the top Antenna Bracket Clamp.
PowerBridge M5 X3 7. Connect the other end of the Ethernet cable from the PowerBridge to the Ethernet port labeled POE on the PoE Adapter. 8. Connect an Ethernet cable from your LAN to the Ethernet port labeled LAN on the PoE Adapter.
Hardware Installation 9. Connect the power cord to the power port on the PoE Adapter. Connect the other end of the power cord to a power outlet. 10. Place the GPS Patch Antenna on the mounting hardware.
PowerBridge M5 X3 Accessing the AirOS Utility 1. Make sure that your host machine is connected to the LAN that is connected to the PowerBridge. 2. Configure the Ethernet adapter on your host system with a static IP address on the 192.168.1.x subnet (e.g. 192.168.1.100). 3. Launch your Web browser and type http://192.168.1.20 in the address field and press enter (PC) or return (Mac). 4. The login screen will appear. Enter ubnt in the Username and Password fields. Select your Country and Language.
Specifications Specifications Enclosure Size 445 x 416 x 34 mm Weight 3.82 kg Max Power Consumption 8 Watts Power Supply Power Method Operating Temperature Operating Humidity 48V, 0.
PowerBridge M5 X3 Safety Notices 1. Read, follow, and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in location that can be submerged by water. WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning. Electrical Safety Information 1.
General Warranty General Warranty UBIQUITI NETWORKS, Inc (“UBIQUITI NETWORKS”) represents and warrants that the Products furnished hereunder shall be free from defects in material and workmanship for a period of one (1) year from the date of shipment by UBIQUITI NETWORKS under normal use and operation. UBIQUITI NETWORKS sole and exclusive obligation under the foregoing warranty shall be to repair or replace, at its option, any defective Product that fails during the warranty period.
PowerBridge M5 X3 (II) No modification, alteration or addition has been made to the Product by persons other than UBIQUITI NETWORKS or UBIQUITI NETWORK’S authorized representatives or otherwise approved by UBIQUITI NETWORKS. (III) The Product has been properly installed and used at all times in accordance, and in all material respects, with the applicable Product documentation. (IV) All Ethernet cabling runs use CAT5 (or above) shielded cabling.
Compliance cause harmful interference to radio communications. Operations of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. RF Exposure Warning The transceiver described here emits radio frequency energy. Although the power level is low, the concentrated energy from a directional antenna may pose a health hazard.
PowerBridge M5 X3 Declaration of Conformity Česky [Czech] UBIQUITI NETWORKS tímto prohla uje, e tento UBIQUITI NETWORKS device, je ve shod se základními po adavky a dal ími p íslu n mi ustanoveními sm rnice 1999/5/ES. Dansk [Danish] Undertegnede UBIQUITI NETWORKS erklærer herved, at følgende udstyr UBIQUITI NETWORKS device, overholder de væsentlige krav og øvrige relevante krav i direktiv 1999/5/EF.
Declaration of Conformity Latviski [Latvian] Ar o UBIQUITI NETWORKS deklar , ka UBIQUITI NETWORKS device, atbilst Direkt vas 1999/5/EK b tiskaj m pras b m un citiem ar to saist tajiem noteikumiem. Lietuviškai [Lithuanian] UBIQUITI NETWORKS deklaruoja, kad šis UBIQUITI NETWORKS įrenginys atitinka esminius reikalavimus ir kitas 1999/5/EB Direktyvos nuostatas.
English We recommend that you protect your networks from the most brutal environments and devastating ESD attacks with industrial‑grade shielded Ethernet cable from Ubiquiti Networks. For more details, visit www.ubnt.com/toughcable Deutsch Schützen Sie Ihre Netzwerke vor extremen Umwelteinflüssen und verheerender elektrostatischer Entladung (ESD), indem Sie abgeschirmte Ethernetkabel in Unternehmensqualität von Ubiquiti Networks verwenden. Weitere Informationen erhalten Sie unter www.ubnt.
Ubiquiti Networks Support Email: support@ubnt.com Phone (9 a.m. - 5 p.m. PST): 408-942-1153 Online Resources Wiki Page: www.ubnt.com/wiki Support Forum: www.ubnt.com/forum Knowledge Base: www.ubnt.com/kb Downloads: www.ubnt.com/support/downloads www.ubnt.com © 2011 Ubiquiti Networks, Inc. All rights reserved.
