User`s guide

TX Antenna – choose the single antenna Main or Aux for
transmitting.
RX Antenna – choose the single antenna Main or Aux for receiving.
System
This page enables administrator to reboot the subscriber station, set it
to factory defaults, upload a new firmware and configure
administrator’s credentials.
Firmware
Use only an official Ubiquiti
firmware image for update.
Use this section to find out current software version and update with
new firmware.
The LiteStation2/LiteStation5 subscriber station system firmware
update is compatible with all configuration settings. When the device
is updated with a newer version or the same version builds, all the
system’s configuration will be preserved after the upgrade.
Figure 13 – Firmware Upgrade 1
Firmware version: displays version of the current firmware.
Upgrade…: click to load the device firmware upgrade window.
Click the Upgrade… button and the new Firmware Upload pop-up
window will be displayed:
Figure 14 – Firmware Upgrade 2
Current Firmware: displays version of the current firmware.
Do not switch off and do not
disconnect the
LiteStation2/LiteStation5 from
the power supply during the
firmware upgrade process as this
can damage the device!
Firmware File: click the Browse… button to specify the new firmware
image location or specify the full path and click the Upload button.
Close this window – cancel the upload process.
The new firmware image is uploaded on the system, use Upgrade
button to upgrade a new system firmware:
16