User`s guide

16
Figure 15 – Router mode Network Settings
There are two network segments (WLAN and LAN) configured separately when device
is operating in Router mode.
Wireless network segment can be configured in WLAN Network Settings section:
IP Address: enter IP address of the WLAN interface.
Netmask: enter a subnet mask of the WLAN interface.
Enable NAT: control will enable Network Address Translation (Masquerading) feature
between WLAN and LAN interfaces.
Enable DHCP Server: control will enable DHCP Server feature on WLAN interface.
The DHCP options should be configured while DHCP Server is enabled:
Range Start: Enter the IP address that begins the range of IP address space reserved
for DHCP.
Range End: Enter the IP address that ends the range of IP address space reserved for
DHCP.
Netmask: Enter the subnet mask of IP address space reserved for DHCP.
Lease Time: Enter the lease period (in seconds) during which DHCP guarantees that
the IP address assigned to one particular client is not reassigned to another client.
LAN (Ethernet) connection settings can be configured in LAN Network Settings section
which is identical to the bridge mode Network Settings section described above.