User's Manual
Table Of Contents
15
EdgeSwitch User Guide
Ubiquiti Networks, Inc.
Chapter 5: System Settings
Chapter 5: System Settings
The System Settings screen allows you to configure and use
the Device Name, Management IP, Spanning Tree Protocol,
Services, and System Actions, including configuration
backup and restore, as well as firmware update.
Reset To cancel your changes, click Reset.
Apply To immediately save your changes, click Apply.
Device Name
Device Name Specify the Device Name (hostname),
which is the system-wide device identifier. The SNMP
agent reports it to authorized management stations. The
Device Name will be used in popular router operating
systems, registration screens, and discovery tools.
Management IP
The Management IP settings configure the IP settings of
the EdgeSwitch.
The IP Address and Subnet Mask are not mandatory
for a Layer2 device such as the EdgeSwitch; however,
they must be configured if you want to manage the
EdgeSwitch (and will not be using DHCP).
Configure the Management VLAN ID and then configure
the appropriate section(s): IPv4 or IPv6.
Note: The Management VLAN ID is shared for IPv4
DHCP and static modes, as well as IPv6.