User's Manual

18
EdgeSwitch User Guide
Ubiquiti Networks, Inc.
Chapter 5: System Settings
SSH Server
Enabled/Disabled SSH access to the device is enabled by
default.
• Server Port Specify the TCP/IP port of the SSH server.
The default is 22.
Telnet Server
Enabled/Disabled Disabled by default. Enabling this
option activates Telnet access to the device.
• Server Port Specify the TCP/IP port of the Telnet server.
The default is 23.
Web Server
HTTPS is enabled by default. The following Web Server
parameters can be set:
Server Port For HTTP mode, specify the TCP/IP port of the
web server. The default is 80.
Secure Server Port For secure HTTPS mode, specify the
TCP/IP port of the web server. The default is 443.
SNTP Client
Simple Network Time Protocol (SNTP) is a simplified
version of NTP, a protocol for the synchronization of
network device clocks using an SNTP server. You can use
it to set the system time on the device, and the system
time is reported next to every log entry that registers a
systemevent.
Enabled/Disabled Enabled by default. The device obtains
the system time from a time server on the internet.
• NTP Server 1 Specify the IP address or domain name of
the primary NTP server. The default is as follows:
1.ubnt.pool.ntp.org
• NTP Server 2 Specify the IP address or domain name of
the secondary NTP server. The default is as follows:
2.ubnt.pool.ntp.org
System Actions
This section manages device configuration routines,
firmware updates, and the option to reset the device to
factory default settings.
Backup
Backup Click
BACKUP
to download the current system
configuration file. The device configuration is stored as a
gzipped tar archive (.tar.gz). You can back up, restore, or
update the system configurationfile:
Note: We strongly recommend that you save
the configuration file in a secure location. The
configuration file includes confidential information,
such as hashed passwords.
Restore
Note: We recommend that you back up your current
system configuration before uploading the new
configuration.
The configuration file must match the device you are
uploading to. Behavior may be unpredictable if you mix
configuration files from different device models. For
example, upload an ES-16-150W configuration file to an
ES-16-150W; do NOT upload an ES-24-Lite configuration
file to an ES-16-150W.
Restore Click
RESTORE
to locate the new configuration
file. Select the file and then click Open to upload the new
configuration file to the EdgeSwitch.
After the EdgeSwitch reboots, the settings of the new
configuration are displayed in the Configuration Interface.