User Manual

8
EdgeSwitch User Guide
Ubiquiti Networks, Inc.
Chapter 3: Dashboard
Device Status
(Device Name) Displays the customizable name or
identifier of the device. The Device Name (also known
as hostname) is displayed in registration screens and
discovery tools.
(Uptime) This is the total time the device has been
running since the latest reboot (when the device was
powered up) or software upgrade. The time is displayed in
days, hours, minutes, and seconds.
(Firmware) Displays the firmware version of the device.
MAC Address Displays the Media Access Control (MAC)
address of the device.
IP Address Displays the local IP address of the device.
Port Status
(Port) Displays the number of the port.
Link Status Displays the speed, activity status, and PoE
feature of the port.
Color Status
10/100 Mbps Link
10/100 Mbps Link with PoE
1000 Mbps/1 Gbps Link
1000 Mbps/1 Gbps Link with PoE
10 Gbps Link
Disabled
Disconnected
Disconnected with PoE
Click a port to access its advanced settings. Go to
“Advanced Settings” on page 10 for more information.
Port Summary
(checkbox) Select multiple ports for group configuration.
• Aggregate If you have multiple ports selected, click
Aggregate to configure LAG options for them. The LAG
window appears and displays the following:
- (Add) Click an existing LAG to add the selected ports.
- (Create) Click the Create icon to create a new LAG.
Go to “Create or Edit a LAG” on page 9.
- (Edit) (Available if the selected ports belong to the
same LAG.) Click the Edit icon to configure LAG
settings. Go to “Create or Edit a LAG” on page 9.
- (Delete) (Available if the selected ports belong to the
same LAG.) Move the cursor over the current LAG .
When the check mark becomes an X, click it to remove
the selected ports from the LAG.
- (Delete from current LAGs) (Available if the selected
ports belong to different LAGs.) Click the Delete icon
to remove the selected ports from the current LAGs.
• (Advanced Settings) Configure settings for the
selected ports. Go to “Advanced Settings” on page
10 for more information.
Port Displays the number of the port.
Port Name Displays the name of the port. Click to change
the name.
RX Displays the current RX throughput in blue.
TX Displays the current TX throughput in green.
PoE Displays the status and voltage of the PoE feature.
Active PoE is displayed in blue. To disable PoE, select Off.
To enable 24V passive PoE, select 24V. The default is PoE+.