3-Port Router Model: ERLite-3
Introduction Introduction Thank you for purchasing the Ubiquiti Networks™ EdgeRouter™ Lite, which is part of the EdgeMAX™ platform. For more information, visit www.ubnt.com/edgemax This Quick Start Guide is designed to guide you through the installation and show you how to access the EdgeOS™ Configuration Interface. This Quick Start Guide also includes the warranty terms and is for use with the EdgeRouter Lite, model ERLite-3.
EdgeRouter™ Lite Quick Start Guide Hardware Overview Front Panel Ports Console Ethernet (eth0-eth2) eth0 eth1 Reset eth2 Interface Description Console RJ45 serial console port for Command Line Interface (CLI) management. Use a RJ45-to-DB9, serial console cable, also known as a rollover cable, to connect the Console port to your computer. (If your computer does not have a DB9 port, then you will also need a DB9 adapter.
Hardware Overview Front Panel LEDs The LEDs on the left side of each port are not used at this time. Below is a description of the right LED functionality: Power Speed/Link/Act 10/100 Mbps Speed/Link/Act 1000 Mbps eth0 Ethernet (0-2) Console LED eth1 eth2 State Status Off EdgeRouter Lite not powered on. Green EdgeRouter Lite is powered on.
EdgeRouter™ Lite Quick Start Guide Hardware Installation Mount the EdgeRouter Lite on a wall or place it on a bench top. Note: Keep 20 mm of clearance next to the ventilation holes for adequate airflow. Cabling Requirements • For indoor applications, use Category 5 (or above) UTP cabling approved for indoor use. • For outdoor applications, shielded Category 5 (or above) cabling should be used for all wired Ethernet connections and should be grounded through the AC ground of the power supply.
Hardware Installation 3. Position the EdgeRouter Lite with the Ethernet ports facing down. Place the Wall-Mount Slots of the EdgeRouter Lite over the screw heads on the wall. Then slide the EdgeRouter Lite down to lock it into place. 12 V DC Grounding the EdgeRouter Lite (Recommended) The EdgeRouter Lite is grounded through the Power Adapter; however, you can add optional ESD grounding for enhanced ESD protection. 1.
EdgeRouter™ Lite Quick Start Guide Connecting Power 1. Connect the Power Adapter to the Power port. 2. Connect the Power Cord to the Power Adapter. Connect the other end of the Power Cord to a power outlet.
Hardware Installation Accessing the EdgeOS Configuration Interface 1. Connect an Ethernet cable from the Ethernet port of your computer to the port labeled eth0 on the EdgeRouter Lite. eth2 eth1 eth0 2. Configure the Ethernet adapter on your host system with a static IP address on the 192.168.1.x subnet (e.g., 192.168.1.100). 3. Launch your web browser. Type https://192.168.1.1 in the address field. Press enter (PC) or return (Mac). 4. The login screen will appear.
EdgeRouter™ Lite Quick Start Guide Specifications EdgeRouter Lite Dimensions Weight Power Input Button Processor System Memory 200 x 90 x 30 mm 345 g 12VDC, 1A Power Adapter (Included) Reset Dual-Core 500 MHz, MIPS64 with Hardware Acceleration for Packet Processing 512 MB DDR2 RAM Code Storage 2 GB Certifications CE, FCC, IC Wall-Mount Operating Temperature Operating Humidity Yes -10 to 45° C 90% Non-Condensing LEDs Per Port Serial Console Port Data Ports Power Speed/Link/Activity Networking Int
Safety Notices Safety Notices 1. 2. 3. Read, follow, and keep these instructions. Heed all warnings. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in location that can be submerged by water. WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning. Electrical Safety Information 1.
EdgeRouter™ Lite Quick Start Guide Limited Warranty UBIQUITI NETWORKS, Inc (“UBIQUITI NETWORKS”) warrants that the product(s) furnished hereunder (the “Product(s)”) shall be free from defects in material and workmanship for a period of one (1) year from the date of shipment by UBIQUITI NETWORKS under normal use and operation.
Compliance THE INTERNET, AND THAT THE PRODUCTS AND SERVICES MAY BE SUBJECT TO LIMITATIONS, INTERRUPTIONS, DELAYS, CANCELLATIONS AND OTHER PROBLEMS INHERENT IN THE USE OF COMMUNICATIONS FACILITIES. UBIQUITI NETWORKS, ITS AFFILIATES AND ITS AND THEIR THIRD PARTY PROVIDERS ARE NOT RESPONSIBLE FOR ANY INTERRUPTIONS, DELAYS, CANCELLATIONS, DELIVERY FAILURES, DATA LOSS, CONTENT CORRUPTION, PACKET LOSS, OR OTHER DAMAGE RESULTING FROM ANY OF THE FOREGOING.
EdgeRouter™ Lite Quick Start Guide Industry Canada This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 Canada. Australia and New Zealand Warning: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
Compliance Español La Directiva 2002/96/CE de la UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados. El símbolo indica que el producto en cuestión debe separarse de los residuos domésticos convencionales con vistas a su eliminación.
EdgeRouter™ Lite Quick Start Guide Declaration of Conformity Česky [Czech] UBIQUITI NETWORKS tímto prohla uje, e tento UBIQUITI NETWORKS device, je ve shod se základními po adavky a dal ími p íslu n mi ustanoveními sm rnice 1999/5/ES. Dansk [Danish] Undertegnede UBIQUITI NETWORKS erklærer herved, at følgende udstyr UBIQUITI NETWORKS device, overholder de væsentlige krav og øvrige relevante krav i direktiv 1999/5/EF.
Declaration of Conformity Latviski [Latvian] Ar o UBIQUITI NETWORKS deklar , ka UBIQUITI NETWORKS device, atbilst Direkt vas 1999/5/EK b tiskaj m pras b m un citiem ar to saist tajiem noteikumiem. Lietuviškai [Lithuanian] UBIQUITI NETWORKS deklaruoja, kad šis UBIQUITI NETWORKS įrenginys atitinka esminius reikalavimus ir kitas 1999/5/EB Direktyvos nuostatas.
EdgeRouter™ Lite Quick Start Guide Mounting Template The recommended mounting orientation is horizontal with the ports facing down. Turn this page sideways to mark the holes. 100 mm Note: The EdgeRouter Lite can also be mounted in a vertical orientation. Keep the page oriented as-is to mark the holes for vertical placement.
Support support.ubnt.com Community community.ubnt.com Downloads downloads.ubnt.com www.ubnt.com © 2012-2013 Ubiquiti Networks, Inc. All rights reserved.
