User guide

23
Chapter 5: Wireless TabairFiber
®
AF5/AF5U User Guide
Ubiquiti Networks, Inc.
Chapter 5: Wireless Tab
The Wireless tab contains options to set up the wireless
part of the link. This includes wireless mode, link name,
frequencies, output power, speed, and wireless security.
Change To save or test your changes, click Change.
A new message appears. You have three options:
• Apply To immediately save your changes, click Apply.
• Test To try the changes without saving them, click Test.
To keep the changes, click Apply. If you do not click
Apply within 180 seconds (the countdown is displayed),
the airFiber AF-5 times out and resumes its earlier
configuration.
• Discard To cancel your changes, click Discard.
Write down the settings you configure on the Wireless tab.
You will need to enter the same settings on the airFiber
AF-5 at the other end of your PtP link. The exceptions are
as follows:
• Wireless Mode Configure one airFiber AF-5 as the
Master and the other as the Slave.
• TX and RX Frequencies The TX Frequency on the
Master should be used as the RX Frequency on the Slave,
and vice versa.
For Half Duplex mode (default), the TX and RX Frequencies
can be the same or different to suit local interference.
TX
RX
TX
RX
Frequency A
Frequency A
SlaveMaster
Half-Duplex Diagram