User guide
11
Chapter 5: Video Tab
Ubiquiti Networks, Inc.
airCam
™
Dome User Guide
Removing the microSD Card
1. Go to the Video tab.
2. Click Remove Memory Card.
3. You will be prompted to confirm. Click OK.
4. Click OK. You can now safely remove the memory card.
Mounting the microSD Card
If you have removed the microSD Card via the Camera
Configuration Interface but have not physically removed
the card from the camera, you can mount the card again
by performing the following steps:
1. Go to the Video tab.
2. Click Mount.
Video Settings
Bit Rate, Kbit/s This option allows the selection of the bit
rate in kilobits per second. Options include 256, 512, 1024,
2048, 4096.
Frame Rate, fps This option allows the selection of the
video frame rate in frames per second. Options include 2,
3, 4, 5, 7, 10, 15, 20, 25, 30.
Refresh Frequency, Hz This option allows the selection
of the video refresh frequency in hertz. Options include
50Hz and 60Hz.
RTSP Authentication
Enable RTSP Authentication When RTSP (Real-Time
Streaming Protocol) Authentication is enabled, a
username and password is required to view video streams.
Username Enter a username for RTSP authentication.
Password Enter a password for RTSP authentication.
Video Recording
Once you have inserted and formatted a microSD card,
the Video Recording and SD Card options will appear.
These options are completely separate from the airVision
recording options. The options that are configured here
apply only to microSD card recording.
Off
When this option is set to Off, nothing is recorded on the
microSD card. You can still use the camera for recording
within the airVision software. Any recordings that are
created in airVision will be recorded to the hard drive that
the airVision NVR software is using.
Continuous Record
Enables continuous recording on the Micro SD card.