User's Manual



ConfiguretheWirelessSecurity:
SelecttheAESKeyType,HEXorASCII.
FortheKeyfield:
HEX Enter16bytes(eight,16‐bitHEXvalues:0‐9,A‐F,ora‐f).Youcanomitzeroesandusecolons,similartothe
IPv6format.
 Note:TheairFiberConfigurationInterfacesupports
IPv6formatsexcludingdottedquadand"::"
(double

colon)notation.

ASCII Enteracombinationofalphanumericcharacters(0‐9,A‐Z,ora‐z).
ClickChangeandthenclickApply.
InBandManagementisenabledbydefault,soeachairFiberradiomusthaveauniqueIPAddress.(IftheairFiberradiosusethesameIP
Address,thenyoumayloseaccesstotheairFiberradiosviatheDATAports.)Tochangethenetworksettings:
ClicktheNetworktab.

ChangetheIPAddress,Netmask,andothersettingstomakethemcompatiblewithyournetwork.
ClickChangeandthenclickApply.
RepeattheinstructionsintheairFiberConfigurationsectiononyourotherairFiberradio.AfteryouhaveconfiguredtheairFiberradios,
disconnectthemandmovethemtoyourinstallationsite.




