User's Manual
17
Hardware Installation
6. Attach the Azimuth Support Brackets together.
a. Insert the two M10x100 Bolts into the Azimuth Support
Bracket that has two slotted holes.
b. Slide the slotted hole of the other Azimuth Support Bracket
over one M10x100Bolt.
c. Place one M10 Flat Washer, M10 Lock Washer, and M10 Hex
Nut on each M10x100 Bolt.
7. Ensure that there is a 10 mm (0.39 in) gap between the head of
each Pre-Installed M10x25 Flanged Bolt and the corresponding
trunnion on the airFiber radio.
10 mm