User's Manual
48
Appendix B: AF-5X and airFiber Multiplexer airFiber X User Guide
Ubiquiti Networks, Inc.
7. Attach the airFiber NxN assembly to the airFiber X or
RocketDish antenna:
a. Align the mounting tabs on the back of the airFiber
NxN Multiplexer with the mounting bracket.
b. Slide the airFiber NxN Multiplexer down to lock it into
place on the bracket.
Note: The airFiber NxN assembly may be
pole-mounted if it cannot be attached to the
antenna. See the Pole-Mounting section for
details.
8. Connect the RF cables from the antenna to the RF
connectors on the airFiber NxN Multiplexer. Connect
+45° to Chain 0 and -45° to Chain 1.
9. Attach the GPS antennas to each of the airFiber 5X
radios.
10. Mount the GPS antennas in a location that has a clear
view of the sky, and is above and as far away from the
radios as possible.
11. Attach the Protective Shrouds:
a. Insert the Protective Shroud’s attachment tab
between the airFiber 5X radio and the 4x4 Radio
Bracket.
b. Push the Protective Shroud down until the
attachment tab locks into place.
12. Secure the grounding wire from each radio to a
grounded mast, pole, tower, or grounding bar.
WARNING: Failure to properly ground your
airFiber radio will void your warranty.
Note: The ground wire should be as short as
possible and no longer than one meter in length.