User's Manual
6
Chapter 2: Installation airFiber X User Guide
Ubiquiti Networks, Inc.
Mount to an Antenna
The airFiberX radio can be mounted to the antenna(s)
listed in “Installation Requirements” on page 3.
The airFiberX Antenna (AF-5G30-S45) is shown in the
following steps:
1. Attach the airFiber X radio to the antenna by aligning
the four tabs on the back of the radio with the slots of
the radio mount. Then slide the radio down to lock it
into place.
2. Attach the RF connectors to the radio in this
combination: +45°to Chain 0 and -45° to Chain 1.
Thenslide the jackets over the RF connectors to
protectthem.
3. Attach the External GPS Antenna (included with the
radio) to the RF connector labeled GPS on the radio.
4. Attach the protective shroud.
a. Align the hash mark on the top of the shroud with
the notch on the dish antenna.
b. Rotate the shroud clockwise until it locks into place.