User Manual

Alignment

3. Observe the LED display and adjust the elevation until the

strongest received signal level is displayed.

Elevation (EL)

Adjustment Bolt

RF Power (-dBm)

4. Repeat steps 1-3 for the Master.

5. On the Slave, repeat steps 2-3 to finalize the alignment.

6. On the Master, repeat steps 2-3 to finalize the alignment.

7. Lock the alignment on both airFiber radios by tightening all

eight Lock Bolts on the Alignment Bracket.

Observe the LED Display on each airFiber AF24 to ensure that the

value remains constant while tightening the Lock Bolts. If the LED

value changes during the locking process, loosen the Lock Bolts,

finalize the alignment of each airFiber AF24 again, and retighten

the Lock Bolts.

Note: There are three methods for fine-tuning the alignment:

• LED display (described above)

• airFiber Configuration Interface

• audio tone (optional equipment required)

Refer to the airFiber AF24 User Guide for instructions on the

airFiber Configuration Interface and audio tone methods. The

User Guide is available at: www.ubnt.com/documentation