Users Manual

FCC Statement
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION
3. The product shall only be connected to a USB interface of version USB2.0
4. Adapter shall be installed near the equipment and shall be easily accessible
5. Operation temperature:-20~25ºC
6. The plug considered as disconnect device of adapter
7.The device complies with RF specifications when the device used at 20cm from your body
8. AC adapter:
Model No.: CW1201000RE
Input: AC100-240V, 50/60Hz 0.4A
Output: DC 12.0V, 1.0A
SHENZHEN XUANTONGWEI TECHNOLOGY CO., LTD. hereby declares that this Wireless Object Detector is in
compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU
This information has to be presented in such a way that the user can readily understand it. Typically, this will necessitate
translation into every local language (required by national consumer laws) of the markets where the equipment is intended to
be sold. Illustrations, pictograms and using international abbreviations for country names may help reduce the need for