Programming instructions

8
Intermec Fingerprint 6.13 – Programmer's Guide
• Extended Instructions:
ERROR
This statement now can set a specified error, in addition to
enabling error-handling and creating error messages in the
Direct Protocol.
FILE& LOAD
An optional leading parameter has been added that specifies the
number of characters to ignore before the real data. This makes
it possible to use the instruction as an MS/DOS command (CR/
LF problem). The instruction is compatible with Fingerprint
6.0.
IMAGE LOAD
An optional leading parameter has been added that specifies the
number of characters to ignore before the real data. This makes
it possible to use the instruction as an MS/DOS command (CR/
LF problem). The instruction is compatible with Fingerprint
6.0.
LAYOUT
Two layout types have been added:
E = Bar code extended field, sets up complex bar code in regard
of:
- Security
- Aspect height
- Aspect width
- Rows in bar code
- Column in bar code
- Truncation
This corresponds to the 6 last parameters in the BARSET
statement.
J = Baradjust (adjust left or adjust right)
This corresponds to the BARADJUST statement.
SYSVAR
New parameter. SYSVAR (25). Not intended for public use.
VERSION$
Supports EasyCoder 401 Linerless and CPU board 1-040700-
30.
• New Instruction:
FONT LOAD
This instruction downloads and converts .ATF fonts to the
printer's internal font format.
• Remaining bugs and limitations:
Please refer to Intermec Fingerprint 6.13 Reference Manual.
1. INTRODUCTION, cont'd.
3. News in Fingerprint
6.13, cont'd.