Programming instructions

Intermec Fingerprint 6.13 – Programmer's Guide

5. FINGERPRINT PROGRAMMING, cont'd.

14. Rebooting the Printer,

cont'd.

• All parameters in Fingerprint instructions will be reset to default.

• The printer performs a number of self-diagnostic tests, e.g.

printhead resistance check (certain models only) and memory

checksum calculations.

• The printer checks for possible optional devices like interface

boards, memory card adapter or cutter.

• The various parts of the printer's memory are searched for

possible startup programs in the following order:

1. Inserted DOS-formatted memory card ("card1:").

2. Printer's RAM memory ("ram:").

3. Inserted Non DOS-formatted memory card ("rom:")

4. Printer's ROM memory ("rom:")

The first startup program encountered will be executed.

Note that rebooting does not change the printer's setup, unless any

physical changes has been done to the printer during the power-off

period, such as a change of printhead density or installation or

removal of an interface board.