Programming instructions

Intermec Fingerprint v7.61 – Programmer’s Reference Manual Ed. 7318
Chapter 5 Bar Codes
The EasyCoder XP- and F-series printers can optionally be fi tted with an
EasySet bar code wand. By reading a special bar code containing encoded
data for one or several setup parameters, the printer’s setup can easily be
changed, even by a person without any knowledge of Intermec Fingerprint,
the Direct Protocol, or their supporting software.
This chapter explains how to create such setup bar codes. You could
print them in your printer and paste them on a board in the vicintity of
the printer. When, for example, the operator needs to switch to another
type of media, he or she will only have to pick up the EasySet wand and
read the appropriate bar code.
The only bar code that can be used is a Code 128 containing the function
character FNC3 (ASCII 130 dec). If the FNC character is missing, the
printer will regard the bar code as containing ordinary ASCII input to
the "wand:" device.
Please refer to the EasySet Bar Code Wand Setup manual for syntax
and parameter descriptions
Setup Bar Codes