Programming instructions
Intermec Fingerprint v7.61 – Programmer’s Reference Manual Ed. 726
Chapter 2 Program Instructions
BARSET
Field of Application
Statement specifying a bar code and setting additional parameters
to complex bar codes.
Syntax BARSET[#<ncon>,][<sexp>[,<nexp
1
>[,<nexp
2
>[,<nexp
3
>[,<nexp
4
>[,<nexp
5
>
[,<nexp
6
>[,<nexp
7
>[,<nexp
8
>[,<nexp
9
>[,<nexp
10
>]]]]]]]]]]]
#<ncon> is the the start parameter in the syntax above.
<sexp> is the barcode type.
<nexp
1
> is the ratio of the large bars.
<nexp
2
> is the ratio of the small bars.
<nexp
3
> is the enlargement.
<nexp
4
> is the height of the code in dots.
<nexp
5
> is the security level according to bar code specifi cation.
<nexp
6
> is the aspect height ratio.
<nexp
7
> is the aspect width ratio.
<nexp
8
> is the number of rows in the bar code.
<nexp
9
> is the number of columns in the bar code.
<nexp
10
> is a truncate fl ag according to bar code specifi cations
Reset to default by: PRINTFEED execution.
Remarks
This statement can replace the statements BARHEIGHT, BARRATIO,
BARTYPE, and BARMAG. Although being primarily intended for some
complex bar codes such as PDF417, it can be used for any type of
bar code if non-relevant parameters are left out (for example <nexp
5
>
to <nexp
10
>).
Start Parameter:
Start parameter specifi es which parameter in the syntax above should be
the fi rst parameter (#1-11). Thereby you may bypass some of the initial
parameters, for example barcode type, ratio, and enlargement.
Default value: #1
Bar Code Type:
The bar code type parameter corresponds to the BARTYPE statement.
Default bar code: "INT2OF5"
Bar Code Ratio:
The two ratio parameters correspond to the BARRATIO statement.
Default value: 3:1
Enlargement:
The enlargement parameter corresponds to the BARMAG statement.
Default value: 2
Bar Code Height:
The height parameter corresponds to the BARHEIGHT statement.
Default value: 100 dots
Security Level:
The security level is only used in some complex bar codes and should be used
according to the specifi cations of the bar code in question.
Default value: 2