Programming instructions

Intermec Fingerprint v7.61 – Programmer’s Reference Manual Ed. 7252
Chapter 2 Program Instructions
SYSVAR
Field of Application System array for reading or setting various system variables.
Syntax SYSVAR(<nexp>)
<nexp> is the reference number of the system variable:
0 Not intended for public use
1 Not intended for public use
2 Not implemented
3 Not intended for public use
4 Not implemented
5 Not implemented
6 Not implemented
7 Not implemented
8 Not implemented
9 Reserved special applications
10 Reserved special applications
11 Reserved special applications
12 Not implemented
13 Read ribbon counter (XP-series)
14 Read errors since power on
15 Read errors since last SYSVAR(15)
16 Read number of bytes received at execution of STORE INPUT
17 Read number of frames received at execution of STORE INPUT
18 Read or Set verbosity level
19 Read or Set type of error message
20 Read direct or transfer mode
21 Read printhead density (dots/mm)
22 Read number of printhead dots
23 Read status of transfer ribbon sensor
24 Read if startup has occurred since last SYSVAR(24)
25 Read or Set type of Centronics communication
26 Read ribbon low condition (F-series)
27 Not implemented
28 Set paper feed data erase at headlift
29 Read DSR condition on "uart2:"
30 Read DSR condition on "uart3:"
31 Read last sent ACK, NAK, or CAN character in the MUSE protocol.
32 Read odometer value
33 Read DSR condition on "uart1:"
34 Read or Set positioning mode for TrueType characters
35 Setup saving (non-volatile/volatile)
36 Print changes of program modes
37 Set minimum gap length
38 Set equal safe (for TESTFEED)
39 Enable/disable slack compensation
40 Not implemented
41 “Next label not found” at predefi ned feed length
42 Stop media feed in the middle of label gaps