Programming instructions

Intermec Fingerprint v7.61 – Programmer’s Reference Manual Ed. 7 237
Chapter 2 Program Instructions
SETUP, cont.
Examples This example enables a key for branching to the Setup Mode:
10 ON KEY(18) GOSUB 1000
20 KEY(18)ON
.....
1000 SETUP
1010 RETURN
This example shows how a new fi le is OPENed for output and each parameter
in the setup is changed by means of PRINT# statements. Then the fi le is
CLOSEd. Any lines, except the fi rst and the last line in the example, may be
omitted. Finally, the printer’s setup is changed using this fi le.
10 OPEN "tmp:SETUP.SYS" FOR OUTPUT AS #1
20 PRINT#1,"SER-COM,UART1,BAUDRATE,19200"
30 PRINT#1,"SER-COM,UART1,CHAR LENGTH,7"
40 PRINT#1,"SER-COM,UART1,PARITY,EVEN"
50 PRINT#1,"SER-COM,UART1,STOPBITS,2"
60 PRINT#1,"SER-COM,UART1,FLOWCONTROL,RTS/CTS,ENABLE"
70 PRINT#1,"SER-COM,UART1,FLOWCONTROL,ENQ/ACK,ENABLE"
80 PRINT#1,"SER-COM,UART1,FLOWCONTROL,XON/XOFF,DATA FROM HOST,ENABLE"
90 PRINT#1,"SER-COM,UART1,FLOWCONTROL,XON/XOFF,DATA TO HOST,ENABLE"
100 PRINT#1,"SER-COM,UART1,NEW LINE,CR"
110 PRINT#1,"SER-COM,UART1,REC BUF,800"
120 PRINT#1,"SER-COM,UART1,TRANS BUF,800"
130 PRINT#1,"FEEDADJ,STARTADJ,-135"
140 PRINT#1,"FEEDADJ,STOPADJ,-36"
150 PRINT#1,"MEDIA,MEDIA SIZE,XSTART,50"
160 PRINT#1,"MEDIA,MEDIA SIZE,WIDTH,1000"
170 PRINT#1,"MEDIA,MEDIA SIZE,LENGTH,2000"
180 PRINT#1,"MEDIA,MEDIA TYPE,LABEL (w GAPS)"
190 PRINT#1,"MEDIA,PAPER TYPE,TRANSFER"
200 PRINT#1,"MEDIA,PAPER TYPE,TRANSFER,RIBBON CONSTANT,110"
210 PRINT#1,"MEDIA,PAPER TYPE,TRANSFER,RIBBON FACTOR,25"
220 PRINT#1,"MEDIA,PAPER TYPE,TRANSFER,LABEL OFFSET,00"
230 PRINT#1,"MEDIA,CONTRAST,-4%"
240 PRINT#1,"PRINT DEFS,PRINT SPEED,300"
250 CLOSE
260 SETUP "tmp:SETUP.SYS"
This example shows how a setup parameter is changed in the Immediate
Mode or the Intermec Direct Protocol, using a setup string.
SETUP"MEDIA,MEDIA TYPE,VAR LENGTH STRIP" ↵
This method can also be used in the Programming Mode, for example:
10 SETUP"MEDIA,MEDIA TYPE,VAR LENGTH STRIP"