Specifications

Chapter 6— Finding IPL Commands in This Manual
76 IPL Programmer’s Reference Manual
Print Mode Commands
Configuration Commands
Syntax Command Page
<SI>a
Audible Alarm, Enable or Disable 114
<SI>A
Control Panel Access Permission, Set 117
<SI>b
Takeup Motor Torque, Increase 139
<SI>c
Cutter, Enable or Disable 118
<SI>C
Emulation or Advanced Mode on Power-Up 119
<SI>d
Dark Adjust, Set 118
<SI>D
End-of-Print Skip Distance, Set 120
<SI>e
Media Fault Recovery Mode, Set 127
<SI>f
Label Rest Point, Adjust 123
<SI>F
Top of Form, Set 139
<SI>g
Media Sensitivity, Select 127
<SI>h
Printhead Loading Mode, Select 135
<SI>H
Printhead Pressure, Set 136
<SI>i
IBM Language Translation, Enable or Disable 122
<SI>I
Number of Image Bands, Set 129
<SI>l
Printer Language, Select 133
<SI>L
Maximum Label Length, Set 126
<SI>N
Amount of Storage, Define 114
<SI>O
Online or Offline on Power-Up 130
<SI>p
Pin 11/20 Protocol, Set 130
<SI>r
Label Retract Distance, Set 124
<SI>R
Label Retract, Enable or Disable 124
<SI>s
Interlabel Ribbon Save, Enable or Disable 123
<SI>S
Print Speed, Set 132
<SI>t
Self-Strip, Enable or Disable 137
<SI>T
Label Stock Type, Select 125
<SI>U
Printhead Test Parameters, Set 136
<SI>W
Label Width, Set 125
<SI>z
Slash Zero, Enable or Disable 138
<SI>Z
Ribbon Save Zones, Set 137