Specifications

Chapter 5— Advanced Printer Programming
60 IPL Programmer’s Reference Manual
IPL Commands and Emulation Mode (continued)
IPL Command Name Syntax Page
Works in
Emulation Mode?
Print Line Dot Count Limit, Set v 196 N/A
Print Quality Label, Print Q 203 Yes
Print Speed, Set <SI>S 132 Yes
Printer Language, Select <SI>l 133 Yes
Printhead Loading Mode, Select <SI>h 135 No
Printhead Parameters, Transmit <ESC>H 109 Yes
Printhead Pressure, Set <SI>H 136 N/A
Printhead Resistance Test, Begin B 203 N/A
Printhead Resistance Values, Transmit S 203 N/A
Printhead Temperature Sensor Value, Transmit P 203 Yes
Printhead Test Parameters, Set <SI>U 136 N/A
Printhead Volt Supply Value, Transmit V 204 N/A
Program Mode, Enter <ESC>P 109 Yes
Program Mode, Exit R 197 Yes
Program Number, Transmit <ESC>M 110 Yes
Program Number and Model, Transmit <ESC>M 110 Yes
Quantity Count, Set <RS> 110 Yes
Reflective Sensor Value, Transmit M 204 No
Remaining Quantity and Batch Count, Transmit <ESC>Q 87 Yes
Reset <DLE> 87 Yes
Ribbon Save Zones, Set <SI>Z 137 N/A
Self-Strip, Enable or Disable <SI>t 137 Yes
Slash Zero, Enable or Disable <SI>z 138 No
Software Configuration Label, Print s 204 Yes
Start and Stop Codes (Code 39), Print <ESC><SP> 110 Yes
Status Dump <VT> 88 Yes
Status Enquiry <ENQ> 89 Yes
Takeup Motor Torque, Increase <SI>b 139 No
Test and Service Mode, Enter <ESC>T 111 Yes
Test and Service Mode, Exit R 204 Yes
Top of Form, Set <SI>F 139 Yes
Transmissive Sensor Value, Transmit G 204 Yes
User-Defined Character (UDC) and Graphics, Print g 204 Yes
User-Defined Character, Clear or Create G 197 Yes
User-Defined Character Field, Create or Edit U 197 Yes
User-Defined Characters, Transmit <ESC>u 111 Yes
User-Defined Font Character, Create t 198 Yes
User-Defined Fonts, Print t 205 Yes