Specifications

Appendix D— User-Defined Interface Tables
IPL Programmer’s Reference Manual 235
Status Responses and Auto-Transmit Commands (t = 3)
This list contains the status responses and auto-transmit commands in the
order you must download them.
Status Command Hex Value Status Description
GS 1D Buffer Already Full
SO 0E Printhead Test Fail
US 1F Label Path Open
US 1F Ribbon Fault
EM 19 No Label Stock
DC3 13 Buffer Now Full
BS 08 Takeup Reel Full
SI* 0F Printhead Hot
FS 1C Label at Strip Pin
DC1** 11 Skipping
DC1** 11 Printing
DC1** 11 Ready
DC1 Auto-Transmit 1** 11 Clear
FS Auto-Transmit 1 1C Label at Strip Pin
BS Auto-Transmit 1 08 Takeup Reel Full
EM Auto-Transmit 1 19 No Label Stock
US Auto-Transmit 1 1F Ribbon Fault
DC1 Auto-Transmit 2 11 Room in Buffer
HT Auto-Transmit 3 09 Imager Overrun
SOH Auto-Transmit 3 01 Print Job Complete and Buffer
Empty
RS Auto-Transmit 3 1E Insufficient RAM
*Some older Intermec printers may not support this entry.
**The status responses in the above table are for standard protocol. In XON/XOFF
protocol, most of the status responses are the same; however, instead of DC1, the status
response is DC2, and instead of DC2, the status response is DC4.
See your printer user’s manual for more information about protocols and status
responses.