Specifications

Chapter 7— IPL Command Reference
204 IPL Programmer’s Reference Manual
Printhead Volt Supply Value, Transmit
Purpose: Transmits the printhead volt supply A/D output back to the host. The
range of the value is 00 to 255.
Syntax: V
Printer: 4400
Reflective Sensor Value, Transmit
Purpose: Transmits the label mark reflective sensor A/D output back to the host.
The value ranges from 00 to 255. The EasyCoder F4, PF2i, PF4i and
PM4i will not respond if the paper is moving. For these printers, the
values are 0 (label) or 1 (mark).
Syntax: M
Software Configuration Label, Print
Purpose: Prints a label providing software configuration information.
Syntax: s
Test and Service Mode, Exit
Purpose: Causes the printer to exit Test and Service mode.
Syntax: R
Transmissive Sensor Value, Transmit
Purpose: Transmits the label gap transmissive sensor A/D output back to the host.
The value ranges from 00 to 255. The EasyCoder F4, PF2i, PF4i and
PM4i will not respond if the paper is moving. For these printers, values are
0 (gap) or 1 (label).
Syntax: G
User-Defined Characters (UDC) and Graphics, Print
Purpose: Prints the user-defined characters and graphics stored on the printer.
Syntax: g