Specifications

Chapter 7— IPL Command Reference
202 IPL Programmer’s Reference Manual
Factory Defaults, Reset
Purpose: Sets the printer configuration to the factory defaults. When you exit Test
and Service mode after sending this command, the printer performs a
warm boot (it resets).
Syntax: D
Use this example to reset the factory defaults:
<STX><ESC>T;D;R;<ETX>
Formats, Print
Purpose: Prints all stored formats.
Syntax: f
Hardware Configuration Label, Print
Purpose: Prints a label that provides information about the printer’s hardware
configuration.
Syntax: h
Label Path Open Sensor Value, Transmit
Purpose: Transmits the paper path open switch value back to the host. A value of 0
indicates the paper path is open, and a value of 1 indicates it is closed. On
the EasyCoder F4, PF2i, PF4i and PM4i printers, a value of 1 indicates
the paper path is open, and a value of 0 indicates it is closed.
Syntax: L
Printers:
Printer Notes
3400A
3400B
This printer ignores this command.
3600 This printer ignores this command.
Label Taken Sensor Value, Transmit
Purpose: Transmits the label taken sensor A/D output back to the host. The value
can range from 00 to 255. On the EasyCoder F4, PF2i, PF4i and PM4i
printers, a value of 0 indicates the label is removed, and a value of 1
indicates the label is at the strip pin.
Syntax: T