Specifications

Chapter 7— IPL Command Reference
IPL Programmer’s Reference Manual 127
Media Fault Recovery Mode, Set
Purpose: Sets the media fault recovery mode.
Syntax: <SI>en
Printers:
Printer Default Values for n
3400e
n = 0
0 = reprints interrupted label
1 = do not reprint interrupted label
4420
n = 0
0 = reprints interrupted label
1 = do not reprint interrupted label
4440
n = 0
0 = reprints interrupted label
1 = do not reprint interrupted label
7421
n = 0
0 = reprints interrupted label
1 = do not reprint interrupted label
EasyCoder
F4, PF2i,
PF4i, PM4i
n = 0
0 = reprints interrupted label
1 = do not reprint interrupted label
Media Sensitivity, Select
Purpose: Selects the media sensitivity of the printer.
Syntax: <SI>gn[,m]
where n specifies direct thermal (DT) stock or thermal transfer (TTR)
stock, and ,m specifies the sensitivity.
Printers:
Printer Default Values for n Values for ,m Notes
3240 n = 0 0 = Direct thermal
1 = Thermal transfer
420 = Direct thermal
567 = Thermal transfer
You can only set n by
using the DIP switches.
3400A
3400B
n = 0 0 = Direct thermal
1 = Thermal transfer
420 = Direct thermal
567 = Thermal transfer
You can only set n by
using the DIP switches.
3400C
3400D
n = 0 0 = Direct thermal
1 = Thermal transfer
470 = Direct thermal
567 = Thermal transfer
You can only set n by
using the DIP switches.
3400e n = 0 0 = Direct thermal
1 = Thermal transfer
470 = Direct thermal (2-5 ips)
720 = Direct thermal (6-8 ips)
567 = Thermal transfer
You can only set n by
using the DIP switches.
3440 n = 0 0 = Direct thermal
1 = Thermal transfer
470 = Direct thermal
567 = Thermal transfer
You can only set n by
using the DIP switches.
3600 n = 0 0 = Direct thermal
1 = Thermal transfer
420 = Direct thermal
567 = Thermal transfer
You can only set n by
using the DIP switches.