Specifications

Chapter 7— IPL Command Reference
IPL Programmer’s Reference Manual 125
Label Stock Type, Select
Purpose: Selects the type of label stock.
Syntax: <SI>Tn
where n specifies the type of stock.
Printers:
Printer Default Values for n Notes
All n = 1
0 = Continuous label stock (no
breaks between labels)
1 = Label stock with gaps between
labels
2 = Label stock with marks between
labels (on back of label stock)
All printers support this
command the same way.
Notes: To make this command effective, reset the printer or turn the power off
and on again after issuing the command.
Label Width, Set
Purpose: Sets the label width to n in dot increments.
Syntax: <SI>Wn
where n is a number between the minimum and maximum number of
dots for your printer. Calculations for all printers (except the 4440 printer)
use a 5 mil dot.
Printers:
Printer Default Values for n Notes
4400
n = 896
n = 672
(6.5 mil printhead)
50 to 896
or
50 to 672
This command is effective
upon execution.
44X0
4420: n = 896
4440: n = 1792
4420: 50 to 896
4440: 100 to 1792
This command is effective
upon execution. For the
4440 printer, n must be
calculated using 2.5 mil
dot.
7421 n = 832 50 to 832
This command is effective
upon execution.
Notes: (44X0 only) When you print narrower labels, set this command to reduce
torque. You may need to experiment with this command until your labels
print properly. In high humidity environments, you may also want to use
the Takeup Motor Torque, Increase command.