Specifications

Chapter 7— IPL Command Reference
124 IPL Programmer’s Reference Manual
Label Retract, Enable or Disable
Purpose: Turns the label retract option on or off.
Syntax: <SI>Rn
where n enables or disables the label retract option.
Printers:
Printer Default Values for n Notes
All n = 1
0 = Disables label retract
1 = Enables label retract
All printers support this command
the same way.
Notes: If you select die-cut label stock, the printer determines the retract distance
automatically.
If you select continuous label stock, the printer uses the retract distance set
by the Set Label Retract Distance (Label Retract Distance, Set) command.
See also the Select Label Stock Type (Label Stock Type, Select) command.
Label Retract Distance, Set
Purpose: Sets the label retract distance.
Syntax: <SI>rn
where n specifies the label retract distance in 5 mil increments.
Printers:
Printer Default Values for n Notes
4400
n = 284
n = 216 (6.5 mil printhead)
0 to 399
All other
printers
n = 0 0 to 399
All other printers support this
command the same way.
Notes: This command works with continuous label stock only. The label retracts
to this distance at the start of a print.