Specifications

Chapter 7— IPL Command Reference
IPL Programmer’s Reference Manual 115
Auto-Transmit 1, Enable
Purpose: Enables auto-transmit level 1.
Syntax: <ESC>j
Notes: The printer uploads the status in the following order of priority for
Intermec Standard Protocol. See Appendix D, “User-Defined Interface
Tables,” for codes for other protocols.
<DC1> Fault cleared.
(<DC2> transmitted when Flow Control Protocol selected.)
<FS> Label at strip pin
<BS> Takeup reel full
<EM> No label stock
<US> Ribbon fault
<US> Label path open
Auto-Transmit 2, Enable
Purpose: Enables auto-transmit level 2.
Syntax: <ESC>d
Notes: At level 2, the printer automatically transmits the status response code
indicating room in input buffer (<DC1> for Standard Protocol and
<DC2> for Flow Control Protocol). Without auto-transmit enabled, the
host must use the <ENQ> or <VT> command to determine the status.
Auto-Transmit 3, Enable
Purpose: Enables auto-transmit level 3.
Syntax: <ESC>e
Notes: The printer transmits a status response when this condition occurs:
<HT> Imager overrun
<SOH> Printing is complete and the buffer is empty
<RS> Insufficient RAM for printing or storage
Auto-Transmit 1, 2, and 3, Disable
Purpose: Disables the auto-transmit status responses.
Syntax: <ESC>k