Specifications

Chapter 7— IPL Command Reference
112 IPL Programmer’s Reference Manual
User-Defined Tables, Transmit
Purpose: Causes the printer to upload the user-defined command and protocol
tables that the printer receives to download a new command set.
Syntax: <ESC>Zt
where t identifies the table.
Printers:
Printer Values for t Notes
All except the
EasyCoder F4,
PF2i, PF4i, PM4i,
and 7421
0 = Print mode commands
1 = Escape print commands
2 = Shift print commands
3 = Status response
4 = Protocol characters
All printers support this
command the same way.
Notes: You can find tables listing the default values in Appendix D, “User-
Defined Interface Tables.”
The printer generates an error code (12) if you enter an invalid number.
Use this command to substitute protocol and command characters.
Warm Boot
Purpose: Resets the printer with a warm boot.
Syntax: <BS>
Notes: Unlike the <DLE> command, this command does not take effect
immediately. The printer executes all previous commands before the warm
boot takes effect.
You will lose any data that is sent after this command and before the
printer finishes rebooting. Use this command when configuration changes
require a printer reset.