Specifications

Chapter 7— IPL Command Reference
IPL Programmer’s Reference Manual 95
Data Shift – International Characters (continued)
Use <SUB> to send the following command characters as data:
<ACK> <DC4> <FF> <NUL> <SYN>
<BEL> <EM> <FS> <RS> <US>
<BS> <ENQ> <GS> <SI> <VT>
<CAN> <EOT> <HT> <SO>
<CR> <ESC> <LF> <SOH>
<DC2> <ETB> <NAK> <SUB>
Use <DLE> to send these command characters as data:
<DC1> <DC3> <STX> <ETX>
To send <DLE> as data, preface it with the command <SUB><DLE>.
This example illustrates using the Data Shift command to print control or
command characters in a data field.
<STX<ESC>C<ETX>
<STX><ESC>P<ETX>
<STX>E1;F1;<ETX>
<STX>H0;o750,10;f3;c0;h3;w2;b10;d0,50<ETX>
<STX>B1;o300,10;f3;c0;h200;w1;i1;r2<ETX>
<STX>B2;o600,10;f3;c0;h200;w1;i1;r2<ETX>
<STX>I1;o75,10;f3;c0;h3;w3<ETX>
<STX>I2;o375,10;f3;c0;h3;w3<ETX>
<STX>R<ETX>
<STX><ESC>E1<ETX>
<STX><CAN><ETX>
<STX>Example for printing control codes<CR><ETX>
<STX><SUB><NUL><SUB><SOH><DLE><STX><DLE><ETX><SUB><EOT>
<SUB><ENQ><SUB><ACK><SUB><BEL><SUB><BS><SUB><HT><SUB><LF>
<SUB><VT><SUB><FF><SUB><CR><SUB><SO><SUB><SI>
<SUB><DLE><DLE>
<SUB><DC1><SUB><DC2><ETX>
<STX><CR><ETX>
<STX><SUB><DC3><SUB><DC4><SUB><NAK><SUB><SYN><SUB><ETB>
<SUB><CAN><SUB><EM><SUB><SUB><SUB>
<ESC><SUB><FS><SUB><GS><SUB><RS><SUB><US><ETX>
<STX><US>1<ETX>
<STX><RS>1<ETX>
<STX><ETB><ETX>