User`s manual

UBI EasyCoder 101 – User's Manual
9
MAINTENANCE
Cleaning on a regular basis is important for life of the printer and
for the printout quality.
1 Lift the printhead and remove the paper web.
2 Insert a Printhead Cleaning Card into the print mechanism,
allowing 2–3 cm (1") to extend in front of the printhead.
3 Lock the printhead in lowered position and slowly pull out the
cleaning card. Repeat if necessary.
4 Using a piece of cloth or blotting paper slightly moistened with
isopropanol, clean the print roller and the dispenser edge.
5 Important!
Allow a couple of minutes for the cleaned parts to get dry before
loading the paper.
Wipe the outside surfaces using a damp piece of cloth. If necessary,
add a mild detergent. Be careful not to allow any water to penetrate
into the interior of the printer.
Protect paper from dust by always keeping the stock compartment
door closed. In case of an external paper supply, it is strongly
recommended that both the actual supply and the web path be
protected by some kind of dust cover. Dirt, sand, grit etc. may
rapidly cause irreparable damage to the printhead.
Cleaning the Printhead and
Print Roller
WARNING!
The printhead and print roller
are very delicate.
Never use any tools to remove stuck
labels or to clean the printhead.
Cleaning Card
PULL/TIREZ
Error
Power
Ready
EasyCoder 101
UBI
UBI
Lift Lever
External Cleaning
Protection Against Dust
CAUTION!
Remove the power cord
before cleaning.
Dangerous voltage!