User`s guide

Ubee Interactive Setting Up and Connecting the DVW326
Ubee DVW326 Advanced Wireless Voice Gateway Subscriber User Guide • March 2014 13
3. Power on your PC. The PC must have an Ethernet network adapter or Ethernet port
and an Internet browser installed, such as Firefox or Internet Explorer. The following
browsers are supported:
 For Windows 2000, XP, Vista, Windows 8, Windows 7, Google Chrome, Firefox
1.07 and higher, Internet Explorer v7 and above, Netscape.
 For MAC OS X, 10.2, and higher: Firefox 1.07 and higher, Safari 1.x and higher.
4. Connect the power cable included in the product package to the back of the DVW326
and plug the other end into the power outlet.
5. Insert the SMPCM10 battery into the battery housing on the bottom of the DVW326.
Make sure the battery is inserted past the two clips on each side that hold the battery
in place. The battery “clicks” into place when inserted properly. Use only the model
SMPCM10 battery.
6. Connect the Ethernet cable included in the product package to your computer’s
Ethernet port. Connect the other end to the ETH1, ETH2, ETH3, or ETH4 port on the
DVW326.
7. Connect a coaxial cable from the CABLE port on the back of the device to the cable
wall outlet, or to a cable splitter connected to the wall outlet.
8. Connect an analog telephone (if you will be using the device for telephone service) to
the TEL 1 or TEL 2 port on the back panel of the device. Use the supplied RJ-11
telephone cable.
9. Validate the network connection using the device LEDs to confirm operations.
 The WiFi LED must be flashing or solidly lit.
 The PWR, DS/US, and ONLINE LEDs are solidly lit.
Refer to Understanding LED Behavior on page 6 for more information.
2.1.1 Wall Mount Installation
You can mount the DVW326 on a wall using the 2 mounting brackets on the side of the
device. Two round or pan head screws are recommended. See the figure below.
Label
Size in Millimeters
(mm)
A 6.65 +/- 0.35
B 1.9 +/_ 0.15
C 19.0 +/- 1.2