User guide

Ubee Interactive Using the Primary Network Option
Ubee DDW366 Dual-Band Concurrent Advanced Wireless Gateway Subscriber User Guide • September 2014 74
9.2.1 Enabling a Closed Network on the Primary Network
You can enable the Closed Network option so the SSID cannot be broadcast or seen by
others.
Steps
To enable a closed network:
1. Access the pull down menu for the Closed Network.
2. Choose Enabled to enable a closed network. Automatic Security Configuration is
disabled.
WPS/Disabled Enables or disables WPS option. When enabled, the
following fields are available:
WPS Config State Defines if the WPS has been configured or not.
Device Name Defines a name for this wireless cable modem for WPS.
WPS Setup AP
UUID Defines the universal unique identifier (UUID) for this access
point.
PIN Defines the Personal Identification Number for this access
point.
Generate AP PIN Creates a new PIN for this access point.
WPS Add Client
Add a client Activates wireless protected setup (WPS) security on the
device.
To add a client:
1. Click Add a client. The WPS Add Client screen is
displayed.
2. Click PUSH on the WPS Add Client screen.The WPS
button is activated on the device, indicated by a flashing
white light on top of the unit.
3. Press the WPS button on the device.
Client PIN Defines a PIN number for client access.
Authorized Client MAC Defines the MAC address of the authorized client.
Label Description