User guide

Ubee Interactive Using the Wireless Radio Option
Ubee DDW366 Dual-Band Concurrent Advanced Wireless Gateway Subscriber User Guide • September 2014 68
Label Description
Wireless Interfaces This field allows you to select one of the two radios (2.4GHz
or 5GHz) to actively configure settings for. It displays the
SSID for either the 2.4GHz or 5GHz radio (either the default
SSID or the SSID that has been assigned). This example
shows the setting when the user has chosen to configure
settings for the 2.4GHz band. After selecting Apply, the user
can then return to this field and configure settings for the
5GHZ radio. Refer to Understanding Default Values and
Logins on page 8 for more information on the SSID.
NOTE: The DDW366 is a dual-band concurrent
wireless
gateway, supporting operation of both the 2.4GHz and 5GHz
radio bands simultaneously.
Wireless Displays the wireless radio’s status, Enabled or Disabled.
Country Defines the country where this device is used. The default
value is Q2.
Output Power Output power setup can be one of the following 4 options:
25%, 50%, 75%, or 100%.
802.11 Band Displays which 802.11 band (either 2.4GHz or 5GHz) is
currently being configured.
NOTE: The DDW366 is a dual-band concurrent wireless
gateway, supporting operation of both the 2.4GHz and 5GHz
radio bands simultaneously.
802.11 n-mode Sets the wireless networking standard. Select Auto to use
802.11 n mode when possible. This mode has a significant
increase in the maximum raw OSI physical layer data rate
from 54 Mbit/s to a maximum of 600 Mbit/s with the use of
four spatial streams when at a channel width of 40 MHz.