User guide

3.7 Gateway Ubee Interactive
26 DDW3612 Subscriber User Guide • July, 2010
3.7.6 Gateway - Time
The Time option allows you to configure the system time obtained from network
servers via Simple Network Time Protocol (SNTP). The device must be reset for any
changes to take effect.
1. Access the web interface. Refer to page 7, if needed.
2. Click the Gateway link from the top of the screen.
3. Click Time from the left side of the screen. The Time fields are explained following
this screen example.
Label Description
Enable SNTP Click Yes to enable SNTP (Network Time Protocol). Click No
to disable the feature. SNTP is a protocol for synchronizing
the clocks of computing devices over networks.
Current Time Displays the current system time.
System Start Time Displays the accumulated time since system was started.
Time Server 1 Defines the Time server IP address or Domain name. Use the
one provided, or enter an alternative choice.
Time Server 2 Defines the Time server IP address or Domain name. Use the
one provided, or enter an alternative choice.
Time Server 3 Defines the Time server IP address or Domain name. Use the
one provided, or enter an alternative choice.
Time Zone Offset If needed, define the time zone offset in Hours and Minutes.
For example: 8 means GMT + 08, -1 means GMT -01.
Apply Click Apply to save all screen changes
Reset Values Click Reset Values to reset the screen to factory defaults.