User's Manual

Ubee Interactive — www.ubeeinteractive.com
6 Ubee UBC1307-CA00 – Safety and Installation Product Insert v1.1
Additional Information
1. RESET Button: To reset the device to
factory defaults. Using a pointed object,
insert it into the button opening, and hold
for more than 10 seconds. The device will
reset and reboot. Note: Not all parameters
are reset to factory defaults. Refer to the
User Guide for more information.
2. WPS button: The WPS button located on
the front of the Device, The Wi-Fi Protected
Setup method used to connect a PIN
protected Wi-Fi device to this Device.
LEDs and Other Device Indicators
See the following diagram and descriptions of the
device’s LED behavior, and the behavior of the
back-panel Ethernet indicators.
LED Indicators (Color = Green When On):
POWER—If On, indicates that the device has
successfully completed internal power-on tests.
LED flashes if power-on fails. Note that the LED
flashes briefly immediately after powering the
device.
DS/US—LED flashes once every second while
scanning downstream, once locked, flashes
twice every second while scanning upstream,
solid when online. When the device performs a
firmware upgrade, the LED flashes. When
channel bonding, LED should be Blue otherwise
green.
ONLINE—If On, indicates that the device has
successfully completed internal power-on tests.
LED flashes if power-on fails. Note that the LED
flashes briefly immediately after powering the
device
WiFi—The LED is on (Solid Green) when
enabled and blinking (green) when data is been
passed between the Device and the connected